If you want to be able to listen to your music, audio books or navigation wirelessly via Bluetooth in your car, then the Bluetooth receivers in the BTR series are the solution. You can retrofit wireless A2DP Bluetooth audio streaming to most navigation and car radio systems with the Bluetooth receivers from Ampire.

The connection is easy to set up and is automatically re-established via Bluetooth 4.0. The BTR series uses the Bluetooth protocol for headphones on your smartphone and does not affect the functionality of your Bluetooth hands-free car kit.

The BTR200X Bluetooth receiver has been developed for navigation and car radio systems with a 3.5mm jack input and an on-board power supply of 12 volts. A model with USB power supply can also be ordered as an option - please note this when ordering.


CONNECTIONS

- Sound output: 3.5mm jack plug
- Power supply: +12V ignition (ACC/K15) with 2A fuse
- Remote output: Blue cable +12VDC/20mA


EQUIPMENT

- 3.5mm jack plug with 1.0V signal output
- splash-proof, marine certified
- Automatic switch-on
- Automatic remote output (+12V DC)
- QDL licensed Bluetooth 4.0 (CSR8645)
- A2DP in highest EDR specification
- aptX audio codec from Qualcomm®
- BT Audio Streaming also lossless files such as Wave, Flac, Lossless, etc.
- SSID display name: BTR200X
- 10m range

SMARTPHONE COMPATIBILITY

- Android
- Apple iOS
- Microsoft

OPTIONAL ACCESSORIES

PRC-1 AMPIRE Bluetooth remote control
55100-KLINKE AMPIRE interference suppression filter

TECHNICAL DATA:

- Voltage: +12V DC
- Current consumption including remote output: - Voltage/current remote output: +12V DC, max.20mA
- Bluetooth 4.0
- CSR8645 chip
- aptX audio codec from Qualcomm®
- Frequency range: 20Hz-20kHz
- Coding: Low Complexity Subband Codec (SBC)
- Bit rate: up to 384 kbps (48 kHz sampling)
- Audio output voltage: 1V RMS
- Case dimensions: height: 20mm, width: 65mm, length: 50mm
- Red cable: +12V (0.459mm² or 26x 0.15mm), 305mm long
- Black cable: ground (0.459mm² or 26x 0.15mm), 305mm length
- Blue cable +12VDC/20mA (0.459mm² or 26x 0.15mm), 305mm length

BLUETOOTH APPROVAL:

- Declaration ID D025151
- Referenced Qualified Design ID 56386
- Listing Date 08 December 2014

TEACH-IN THE DEVICE:

- make sure that Bluetooth is switched on on your device
- Switch on the ignition
- the LED (6) flashes blue (pairing mode)
- To connect, select BTR200X in the Bluetooth menu of your device
- After a successful connection, the LED lights up continuously and a single beep sounds over the audio system

NOTE:

- Up to 9 devices can be connected to the BTR200X, but only one device can stream music at a time
- The BTR200X always remembers the last device it was connected to and connects automatically when it is switched on
- a connection to another device must be made manually as described above
- If the connected device is out of range for more than one minute, the connection is automatically interrupted and the BTR200X goes into pairing mode [the LED (6) flashes].
- Can only be used in vehicles and not in continuous operation

OPERATION:

- All settings, such as volume, music selection and play/pause, are made on your device
- the BTR200X can be installed out of sight, as it has no controls or buttons that need to be operated